Tundra 2WD V6-4.0L (1GR-FE) (2005)
d. Perform the operation test without load.
1. Connect the field coil lead wire to terminal C.
Torque: 10 N.m (102 kgf.cm, 89 ft.lbf)
2. Hold the starter with a vise.
3. Connect the battery and ammeter to the starter as shown.
4. Check that the ammeter indicates the specified current.
Specified current: 90 A or less at 11.5 V
Starter (2.0 kW)
TEST
NOTE: These tests must be done within 3 to 5 seconds to avoid the coil to be burned out.
1. INSPECT STARTER ASSEMBLY
a. Do pull-in test.
1. Disconnect the field coil lead wire from terminal C.
2. Connect the battery to the magnetic switch as shown. Check that the clutch pinion gear protrudes.
b. Do holding test.
1. Disconnect the negative (-) lead from the terminal C with the above condition a. is being sustained. Check that the pinion gear remains
protruded.