Tundra 2WD V6-4.0L (1GR-FE) (2005)
3. CONNECT SUCTION HOSE
Connect the suction hose with the clip.
4. INSTALL DRIVE BELT
a. While turning the belt tensioner counterclockwise, align the holes, and then insert a bar of 6 mm (0.24 inch) into the holes to fix the belt
tensioner.
b. Install the drive belt.
c. While turning the belt tensioner counterclockwise, remove the bar.
d. If it is hard to install the drive belt, perform the following procedure:
1
Wrap the drive belt around all the pulleys and idlers, except for the vane pump assembly, as shown in the illustration.
2
While releasing belt tension by turning the belt tensioner counterclockwise, wrap the drive belt around the vane pump assembly.
5. ADD POWER STEERING FLUID
6. BLEED POWER STEERING FLUID
7. INSPECT FLUID LEAK
8. INSTALL ENGINE UNDER COVER