toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

All Technical Service Bulletins for Wiring Harness: > < A/T Controls - MIL ON/DTC P2742 Set
Page 2
background image

Required SSTs

Repair Procedure

1.

To start diagnosis of the vehicle for DTC P2742, refer to the Technical Information System (TIS), applicable model and model year Repair
Manual:

Diagnostics: Automatic Transmission (A750): P2740, P2742 or P2743.

2.

Monitor transmission fluid temperature sensor No. 2 during diagnosis and watch for a short circuit to intermittently occur.

NOTE:

If a short circuit is occurring, the transmission fluid temperature sensor No. 2 will read 302°F (150°C).

3.

If no cause for the short circuit is found following the Repair Manual diagnosis, refer to the following sections on TIS to replace the transmission
wire harness (P/N 82125-351#0).

^

2004 - 2005 model year 4Runner Repair Manual:
Automatic Transmission / Trans: Transmission Wire (A750e/a750f): Replacement

^

2004 - 2005 model year Land Cruiser Repair Manual:

Automatic Transmission: ATF Temperature Sensor: On-Vehicle Repair.

^

2005 model year Sequoia Repair Manual:
Automatic Transmission (A750e, A750F): ATF Temperature Sensor:
On-Vehicle Repair.

^

2005 model year Tacoma Repair Manual:
Automatic Transmission / Trans: Transmission Wire (A750e/a750f): Replacement

^

2005 model year Tundra Repair Manual:
Automatic Transmission (A750e, A750F): ATF Temperature Sensor:
On-Vehicle Repair.

4.

Adjust fluid to proper level.

^

Refer to TIS, applicable model and model year Repair Manual, to properly adjust fluid level.

5.

Test drive vehicle after replacement of transmission wire harness to confirm repair effectiveness.

All Technical Service Bulletins for Wiring Harness: > < A/T Controls - MIL ON/DTC P2742 Set