Tundra 2WD V8-4.6L (1UR-FE) (2010)
Starter Relay: Testing and Inspection
1UR-FE STARTING: STARTER RELAY: ON-VEHICLE INSPECTION
1. REMOVE STARTER RELAY (ST)
(a) Remove the engine room relay box cover.
(b) Remove the starter relay from the engine room relay block.
2. INSPECT STARTER RELAY
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
(b) If the result is not as specified, replace the relay.
3. INSTALL STARTER RELAY