Tundra 4WD V6-3.4L (5VZ-FE) (2004)
Refrigerant Pressure Sensor / Switch: Service and Repair
REMOVAL
1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
HINT: At the time of installation, please refer to the following item.
Evacuate air from refrigeration system.
Charge system with refrigerant and inspect for leakage of refrigerant.
Specified amount:
Double Cab: 530 ± 50 g (18.69 ± 1.76 oz.)
Except Double Cab: 600 ± 50 g (21.16 ± 1.76 oz.)
2. REMOVE PRESSURE SWITCH FROM LIQUID TUBE
Disconnect the connector and remove the pressure switch.
Torque: 10 N.m (100 kgf.cm, 7 ft.lbf)
HINT:
-
Lock the switch mount on the tube with an open end wrench, being careful not to deform the tube, and remove the switch.
-
At the time of installation, please refer to the following item.
Lubricate a new O-ring with the compressor oil and install them to the switch.
INSTALLATION
Installation is in the reverse order of removal.