Tundra 4WD V8-4.7L (2UZ-FE) (2003)
Headliner: Service and Repair
REMOVAL
HINT: Tape the screwdriver tip before using it to remove the parts.
1. Access cab:
REMOVE REAR SEAT
2. REMOVE FRONT DOOR SCUFF PLATES
a. Standard cab:
Remove the 10 screws and front door scuff plates.
b. Access cab:
Remove the 8 screws and front door scuff plates.
3. Access cab:
REMOVE ACCESS DOOR SCUFF PLATES
Remove the 6 screws and access door scuff plates.
4. Access cab:
REMOVE FRONT DOOR REAR SCUFF PLATES
a. Remove the 2 clips and 2 covers.
b. Remove the 2 clips and 2 front door rear scuff plates.
5. REMOVE ASSIST GRIPS
a. Using a screwdriver, remove the caps.
b. Driver's side:
Using a torx driver, remove the 2 torx screws and assist grip
c. Passenger's side:
Using a torx driver, remove the 4 torx screws and 2 assist grips.
6. REMOVE FRONT PILLAR GARNISH
a. Using a screwdriver, remove the front pillar garnish.
b. Employ the same manner described above to the other side.
7. Access cab:
REMOVE FRONT SEAT OUTER BELT ANCHORS