Tundra 4WD V8-4.7L (2UZ-FE) (2003)
2. REMOVE AIRBAG SENSOR ASSEMBLY
a. Disconnect the airbag sensor assembly connectors.
NOTE: Disconnect the connectors with the sensor assembly installed.
b. Using a torx wrench, remove the 4 screws.
Torx wrench: T40 (Part No. 09042 - 00020 or locally manufactured tool)
c. Remove the airbag sensor assembly.
INSTALLATION
NOTE:
-
Never use SRS parts from another vehicle. When replacing parts, replace them with new parts.
-
Never reuse the airbag sensor assembly involved in a collision when the airbag has deployed.
-
Never repair a sensor in order to reuse it.
1. INSTALL AIRBAG SENSOR ASSEMBLY
a. Using a torx wrench, install the airbag sensor assembly with 4 screws.
Torx wrench: T40 (Part No. 09042 - 00020 or locally manufactured tool)
Torque: 20 N.m (205 kgf.cm, 15 ft.lbf)
b. Connect the airbag sensor connectors.
NOTE:
-
Connection of the connector is done after the sensor assembly has been installed.
-
Make sure the sensor assembly is installed with the specified torque.
-
If the sensor assembly has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace the sensor
assembly with a new one.
-
When installing the sensor assembly, take care that the SRS wiring does not interfere with other parts and is not pinched between other
parts.
-
After installing , shake the sensor assembly to check that there is no looseness.
2. INSTALL LOWER CENTER COVER