Tundra 4WD V8-4.7L (2UZ-FE) (2003)
Alignment: Service and Repair
NOTICE: For Zero Point Calibration information, please refer to: TSB T-SB-0020-8 (3/25/08).
FRONT WHEEL ALIGNMENT INSPECTION
1. MEASURE VEHICLE HEIGHT
Measuring points:
A: Ground clearance of the front drive shaft center
B: Ground clearance of the front adjusting cam bolt center
C: Ground clearance of the rear axle shaft center
D: Ground clearance of the leaf spring front side bushing center
Vehicle height:
Front: A - B
Rear: C - D
NOTICE: Before inspecting the wheel alignment, adjust the vehicle height to the specified value.
If the vehicle height is not the specified value, try to adjust it by pushing down on or lifting the body.
2. INSTALL CAMBER-CASTER-KINGPIN GAUGE OR POSITION VEHICLE ON WHEEL ALIGNMENT TESTER
Follow the specific instructions of the equipment manufacturer.
3. INSPECT CAMBER, CASTER AND STEERING AXIS INCLINATION
If the steering axis inclination is not within the specified value, after the camber and caster have been correctly adjusted, recheck the steering
knuckle and front wheel for bearing or looseness.
4. ADJUST CAMBER AND CASTER