Tundra 4WD V8-5.7L (3UR-FE) (2007)
a. Disconnect the sensor connector (labeled A).
b. Detach the 7 clips (labeled B).
c. Remove the bolt (labeled C).
d. Remove the nut (labeled D) and skid control sensor wire.
INSTALLATION
1. INSTALL SKID CONTROL SENSOR WIRE
a. Install the sensor clamp with the nut (labeled A).
Torque: 13 N.m (127 kgf. cm, 9 ft.lbf)
NOTE: Make sure the clamp's rotation stopper touches the installation position.
b. Install the sensor clamp with the bolt (labeled B).
Torque: 13 N.m (127 kgf. cm, 9 ft.lbf)
NOTE: When installing the clamp, do not twist the wire harness.
c. Attach the 7 clips (labeled C).
NOTE:
-
When installing the clamps, do not twist the wire harness.
-
When installing the clamps, securely insert them as shown in the illustration.
d. Connect the sensor connector (labeled D).
NOTE: Securely connect the connector.