Tundra Access Cab SR5 2WD V6-3.4L (5VZ-FE) (2000)
Torque: 50 N.m (510 kgf.cm, 37 ft.lbf)
25.
Install shock absorber with coil spring.
A.
Install the upper side of shock absorber to the chassis frame with the 3 nuts.
Torque: 64 N.m (650 kgf.cm, 47 ft.lbf)
B.
Connect the lower side of shock absorber to the lower suspension arm with bolt, washer, and nut.
Torque: 135 N.m (1,400 kgf.cm, 100 ft.lbf)
26.
Inspect and install the brake rotor and install the brake caliper with new mounting bolts.
A.
Inspect the brake rotors and machine using an on-the-car brake lathe. Replace the rotor if it is below minimum thickness values
Minimum Thickness: 26.0 mm (1.024 in.)
NOTE:
It is necessary to turn the rotors using the on-the-car brake lathe to ensure even and uniform rotor run out. DO NOT turn the rotor using an
off-the-car brake lathe.
B.
Install the disc, brake caliper, and 2 NEW bolts.
Torque:
123 N.m (1,259 kgf.cm, 90 ft.lbf)
C.
Install the brake line clamp to the steering knuckle with the bolt.
Torque:
28 N.m (285 kgf.cm, 21 ft.lbf)
27.
Install new brake line.
Using the SST, connect NEW brake line.
SST P/N: 09023-00100
Torque: 15 N.m (155 kgf.cm, 11 ft.lbf)
28.
With ABS:
Connect the ABS speed sensor and wire harness clamp to the steering knuckle with the 2 bolts.
Torque: 8.0 N.m (82 kgf.cm, 71 in.lbf)
29.
4WD:
Install drive shaft lock nut.
A.
While applying the brakes, tighten the nut.
Torque: 235 N.m (2,400 kgf.cm, 173 ft.lbf)
B.
Install the lock cap and a NEW cotter pin. If the holes for the cotter pin are not aligned, tighten the nut further up to 600.
30.
2WD:
Install grease cap.
31.
Install front wheel.
NOTE:
Do NOT use an air wrench.
Torque: 110 N.m (1,150 kgf.cm, 83 ft.lbf)