Tundra Access Cab SR5 2WD V6-3.4L (5VZ-FE) (2000)
/Page-1169001.png)
Blower Motor: Service and Repair
Removal and Installation
REMOVAL
1. REMOVE COOLING UNIT
2. REMOVE BLOWER UNIT
a. Disconnect the connector from the blower motor.
b. Disconnect the air inlet damper control cable from the blower unit.
HINT: At the time of installation, please refer to the following item.
After connection, adjust the control cable.
c. Remove the nut, bolt and blower unit.
INSTALLATION
Installation is in the reverse order of removal.