Tundra Access Cab SR5 2WD V6-3.4L (5VZ-FE) (2000)
7. DISCONNECT LIQUID TUBE AND DISCHARGE HOSE
Remove the 2 bolts and disconnect the both tube and hose.
Torque: 10 Nm (100 kg.cm, 7 ft.lb)
NOTE: Cap open the fittings immediately to keep moisture or dirt out of the system.
HINT: At the time of installation, please refer to the following item.
Lubricate 2 new O-rings with compressor oil and install them to the tubes.
8. REMOVE CONDENSER
a. Remove the 2 bolts and 2 lower brackets.
b. Remove the 4 bolts and 2 upper brackets.
c. Pull the condenser forward and pull it upward.
HINT: At the time of installation, please refer to the following item.
If condenser is replaced, add compressor oil to the compressor.
Add 40 - 50 cc (1.4 - 1.7 fl.oz.)
Compressor oil: ND-OIL 8 or equivalent
INSTALLATION
Installation is in the reverse order of removal.