Tundra Access Cab SR5 2WD V6-3.4L (5VZ-FE) (2000)
Control Assembly: Service and Repair
Removal and Installation
Air Conditioning Control
REMOVAL
REMOVE CENTER CLUSTER INTEGRATION PANEL
a. Remove the 3 heater control knobs.
b. Remove the 5 screws.
c. Remove integration control panel by pulling the portions indicated by arrows in the illustration.
d. Disconnect the connector.
INSTALLATION
Installation is in the reverse order of removal.
Heater Control
REMOVAL
1. REMOVE CENTER CLUSTER INTEGRATION PANEL
a. Remove the 3 heater control knobs.
b. Remove the 5 screws.
c. Remove integration control panel by pulling the portions indicated by arrows in the illustration.
d. Disconnect the connector.
2. REMOVE LOWER LH FINISH PANEL
3. REMOVE HEATER TO REGISTER DUCT NO.2
4. REMOVE GLOVE COMPARTMENT DOOR
5. REMOVE LOWER NO.2 FINISH PANEL
6. REMOVE HEATER TO REGISTER DUCT NO.4