Toyota Tundra Access Cab SR5 2WD V6-34L (5VZ-FE) Front Wheel Bearing Service and Repair
3. REMOVE AXLE HUB FROM STEERING KNUCKLE
a. Remove the 4 bolts and shift the dust cover towards the hub side (outside).
b. Using SST, remove the axle hub from the steering knuckle.
SST 09710-30021 (09710-03051), 09950-40011 (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04031, 09957-04010,
09958-04011)
c. Remove the dust cover from the steering knuckle.
d. Remove the bearing spacer and ABS speed sensor rotor (w/ABS) /spacer (w/o ABS).
NOTICE: Take care not to scratch the serration of the speed sensor rotor.
4. REMOVE OIL SEAL (OUTSIDE)
Using a screwdriver, remove the oil seal (outside) from the steering knuckle.
5. REMOVE BEARING FROM STEERING KNUCKLE
a. Using snap ring pliers, remove the snap ring.
b. Using SST and a press, remove the bearing from the steering knuckle.
SST 09950-60020 (09951-00810), 09950-70010 (09951-07150)
REASSEMBLY
1. INSTALL NEW BEARING
a. Using SST and a press, install a new bearing to the steering knuckle.
SST 09527-17011, 09950-60020 (09951-00910)
b. Using snap ring pliers, install a new snap ring.