Tundra Access Cab SR5 2WD V8-4.7L (2UZ-FE) (2001)
/Page-1095002.png)
3. REMOVE SHACKLES NO. 1 AND NO. 2
(a) Remove the nut washer and bolt, and remove the load sensing spring and 2 plate washers.
(b) Loosen the 2 nuts and plate washer plate, and remove the shackle No. 1 from the shackle No. 2.
4. DISASSEMBLE LOAD SENSING SPRING
(a) Remove the 4 bushings and 2 collars.
(b) Remove the load sensing valve boot and load sensing spring boot.
INSPECTION
INSPECT VALVE PISTON PIN AND LOAD SENSING CONTACT SURFACE FOR WEAR
Wear limit: 0.7 mm (0.028 inch)
REASSEMBLY
1. ASSEMBLE LOAD SENSING SPRING
(a) Install the load sensing valve boot and load sensing spring boot.