Tundra Access Cab SR5 4WD V8-4.7L (2UZ-FE) (2001)
a. Inspect the SET switch.
1. Push the main switch ON.
2. Drive at a desired speed (40 km/h (25 mph) or higher).
3. Push the control switch downward for the SET/COAST.
4. After releasing the switch, check that the vehicle cruises at the desired speed.
b. Inspect the ACC (acceleration) switch.
1. Push the main switch ON.
2. Drive at a desired speed (40 km/h (25 mph) or higher).
3. Check that the vehicle speed increases while the control switch is turned to RES/ACC, and that the vehicle cruises at the set speed when the
switch is released.
4. Momentarily push the control switch upward in the RES/ACC direction and then immediately release it. Check that the vehicle speed increases
by about 1.5 km/h (Tap-up function).
c. Inspect the COAST switch.
1. Push the main switch ON.
2. Drive at a desired speed (40 km/h (25 mph) or higher).
3. Check that the vehicle speed decreases while the control switch is turned to SET/COAST; and the vehicle cruises at the set speed when the
switch is released.
4. Momentarily push the control switch downward for the SET/COAST, and then immediately release it. Check that the vehicle speed decreases
by about 1.5 km/h (Tap-down function).
d. Inspect the CANCEL switch.
1. Push the main switch ON.
2. Drive at a desired speed (40 km/h (25 mph) or higher).
3. When operating one of the followings, check that the cruise control system is cancelled and that the normal driving mode is reset.
-
Depress the brake pedal.
-
Shift into except D position.
-
Push the main switch OFF.
-
Pull the cruise control switch for CANCEL.