Tundra Regular Cab SR5 4WD V8-4.7L (2UZ-FE) (2000)
a. Using a screwdriver, open the cap.
HINT: Tape the screwdriver tip before use.
b. Remove the screw and coat hook.
14. Standard cab:
REMOVE BACK PANEL UPPER GARNISH
Insert a screwdriver between the back panel upper garnish and body panel to remove the back panel upper garnish.
HINT: Tape the screwdriver tip before use.
15. REMOVE QUARTER TRIM
a. Standard cab:
Remove the bolt and front seat outer belt floor anchor.
Torque: 42 N.m (430 kgf.cm, 31 ft.lbf)
b. Access cab:
Remove the bolt and rear seat outer belt floor anchor.
Torque: 42 N.m (430 kgf.cm, 31 ft.lbf)
c. Using a screwdriver, remove the quarter trim belt hole cover.
HINT: Tape the screwdriver tip before use.