Tundra Regular Cab SR5 4WD V8-4.7L (2UZ-FE) (2000)
3. REMOVE SHACKLES NO. 1 AND NO. 2
a. Remove the nut washer and bolt, and remove the load sensing spring and 2 plate washers.
b. Loosen the 2 nuts and plate washer plate, and remove the shackle No. 1 from the shackle No.
4. DISASSEMBLE LOAD SENSING SPRING
a. Remove the 4 bushings and 2 collars.
b. Remove the load sensing valve boot and load sensing spring boot.
INSPECTION
INSPECT VALVE PISTON PIN AND LOAD SENSING CONTACT SURFACE FOR WEAR
Wear limit: 0.7 mm (0.028 inch)
REASSEMBLY
1. ASSEMBLE LOAD SENSING SPRING
a. Install the load sensing valve boot and load sensing spring boot.
b. Install the 2 collars and 4 bushings.
HINT:
^
Apply lithium soap-base glycol grease to all rubbing areas.