Tundra Regular Cab SR5 4WD V8-4.7L (2UZ-FE) (2000)
c. Remove terminal kit parts.
1. Using SST, loosen the terminal nuts.
SST 09810-38140
2. Terminal C:
Remove the terminal nut, wave washer, terminal insulator (outside), O-ring, terminal bolt, contact plate and terminal insulator (inside).
3. Terminal 30:
Remove the terminal nut, wave washer, terminal insulator (outside), O-ring, terminal bolt, contact plate, terminal insulator (inside) and
insulation paper.
d. Install new terminal 30 kit parts.
1. Temporarily install a new terminal insulator (inside).
2. Temporarily install a new contact plate.
3. Temporarily install a new terminal bolt.
4. Temporarily install a new O-ring.
5. Temporarily install a new packing and new terminal insulator (outside).
Install a new packing to a new terminal insulator, and install them.
HINT: Match the protrusion of the insulator with the indentation of the housing.
6. Temporarily install a new wave washer.
7. Temporarily install a new terminal nut.
NOTE: Be careful to install the terminal insulator (inside) and wave washer in the correct direction.
e. Install new terminal C kit parts.
1. Temporarily install a new terminal insulator (inside).
2. Temporarily install a new contact plate.
3. Temporarily install a new terminal bolt.