Van Wagon 2WD L4-2237cc 2.2L (4Y-EC) (1987)
Distributor: Service and Repair
Distributor Replacement
NOTE: The 7M-GTE engine does not use a distributor. In its place a cam position sensor is used. For removal procedures, refer to CAM POSITION
SENSOR, REPLACE.
1.
Set cylinder No. 1 at TDC compression stroke.
2.
Disconnect wires from spark plugs.
3.
Disconnect electrical leads and vacuum hose (if equipped) from distributor.
4.
Remove distributor hold-down bolt and distributor.
5.
Reverse procedure to install. Ensure cylinder No. 1 is set at TDC compression stroke and distributor rotor is pointing towards No. 1 tower of
distributor cap.