Van Wagon 2WD L4-2237cc 2.2L (4Y-EC) (1987)
Radius Arm: Service and Repair
Fig. 15 Front suspension components. Van w/2 wheel drive
VAN W/2 WHEEL DRIVE
1.
Refer to ``Stabilizer Bar, Replace'' procedure, and remove stabilizer bar.
2.
Remove stabilizer bar bracket from lower control arm, Fig. 15.
3.
Place suitable alignment marks on strut bar.
4.
Remove rear nut from strut bar.
5.
Remove nuts holding strut bar to lower control arm and remove strut bar.
6.
Install strut bar front nut and position according to alignment marks made in step 3. If using new bar position nut 13.07 inches (332 mm) from
inner hole at opposite end of strut bar.
7.
Place washer and bushing on strut bar and position bar in bracket.