Venza AWD L4-2.7L (1AR-FE) (2009)
![background image](/toyota/venza_awd/l4-2.7l_(1ar-fe)/Page-807001.png)
Exhaust Pipe: Service and Repair
Removal
1AR-FE INTAKE / EXHAUST: EXHAUST PIPE: REMOVAL
REMOVAL
CAUTION:
-
Wear protective gloves when removing the exhaust pipe.
-
The exhaust pipe is extremely hot immediately after the engine has stopped.
-
Confirm that the exhaust pipe has cooled down before removing it.
1. REMOVE HEATED OXYGEN SENSOR
(a) Remove the heated oxygen sensor See: Powertrain Management/Computers and Control Systems/Oxygen Sensor/Service and Repair/Heated
Oxygen Sensor/Removal.
2. REMOVE TAIL EXHAUST PIPE BAFFLE SUB-ASSEMBLY
(a) Using a plastic hammer, uniformly tap off the tail exhaust pipe baffle sub-assembly.
3. REMOVE TAIL EXHAUST PIPE ASSEMBLY
(a) Remove the 2 bolts and 2 compression springs.
(b) Remove the tail exhaust pipe assembly from the 4 exhaust pipe supports.
(c) Remove the gasket from the center exhaust pipe assembly.
4. REMOVE CENTER EXHAUST PIPE ASSEMBLY
(a) Remove the 2 bolts.
(b) Remove the center exhaust pipe assembly from the 2 exhaust pipe supports.
(c) Remove the gasket from the center exhaust pipe assembly.
5. REMOVE FRONT EXHAUST PIPE ASSEMBLY