Venza AWD L4-2.7L (1AR-FE) (2009)
(b) Connect each connector.
2. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Installation
3. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Installation
4. INSTALL COWL SIDE TRIM SUB-ASSEMBLY
HINT: Use the same procedure for the RH side and LH side See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Installation.
5. INSTALL FRONT DOOR SCUFF PLATE
HINT: Use the same procedure for the RH side and LH side See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Installation.
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Repair Instruction - Initialization.
7. REGISTER KEY
NOTICE: When replacing the certification ECU (smart key ECU assembly), perform initialization See: Accessories and Optional
Equipment/Antitheft and Alarm Systems/Testing and Inspection/Programming and Relearning/Engine Immobilizer System (w/ Smart Key
System).
8. REGISTER ECU COMMUNICATION ID
NOTICE: When replacing the certification ECU (smart key ECU assembly), perform initialization See: Accessories and Optional
Equipment/Antitheft and Alarm Systems/Testing and Inspection/Programming and Relearning/Engine Immobilizer System (w/ Smart Key
System).