Venza AWD L4-2.7L (1AR-FE) (2009)
Tire Pressure Monitor Receiver / Transponder: Service and Repair
Installation
TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING RECEIVER: INSTALLATION
INSTALLATION
1. INSTALL TIRE PRESSURE WARNING ANTENNA AND RECEIVER
(a) Connect the connector.
(b) Engage the 2 tabs into the holes as shown in the illustration to install the tire pressure warning antenna and receiver.
(c) Install the bolt.
Torque: 8.5 Nm (87 kgf-cm, 75in-lbf)
2. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH
HINT:
-
Refer to the procedures from "Install roof side inner garnish assembly" See: Restraint Systems/Seat Belt Systems/Seat Belt/Service and
Repair/Rear Seat Outer Belt Assembly/Installation.
-
Installation should be performed only for the left side.
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Repair Instruction - Initialization.
4. INSPECT TIRE PRESSURE WARNING SYSTEM
(a) Inspect the tire pressure warning system See: Instrument Panel, Gauges and Warning Indicators/Tire Monitoring System/Testing and
Inspection/Initial Inspection and Diagnostic Overview/Test Mode Procedure.