Venza AWD V6-3.5L (2GR-FE) (2010)
(c) Install the front door lock remote control cable assembly to the front door lock assembly.
(d) Apply MP grease to the sliding parts of the front door lock assembly.
(e) Install a new door lock wiring harness seal to the front door lock assembly.
(f) Insert the front door lock open rod to the front door lock assembly.
(g) Make sure that the front door lock open rod is securely connected to the front door lock assembly.
(h) Apply adhesive to the threads of the bolt.
Adhesive:
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
(i) Using a T30 "TORX" socket wrench, install the front door lock assembly with the 3 screws.
Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)
2. INSTALL FRONT DOOR OUTSIDE HANDLE COVER WITH LOCK CYLINDER ASSEMBLY See: Doors, Hood and Trunk/Doors/Front
Door/Service and Repair/Reassembly