Venza AWD V6-3.5L (2GR-FE) (2010)
Brake Hose/Line: Service Precautions
BRAKE SYSTEM (OTHER): BRAKE LINE: PRECAUTION
1.
TROUBLESHOOTING PRECAUTION
NOTICE:
*
Since the brake lines are critical safety related parts, be sure to disassemble and inspect the components if a brake fluid leak is
found. If any abnormality is found, replace the component with a new one.
*
When removing brake components, cover the brake line connections to prevent foreign matter such as dust or dirt from entering
the lines.
*
Do not damage or deform the brake lines during the removal and installation procedures.
*
When installing a grommet to the body, ensure that the brake line passes through the center of the grommet.
*
When installing a brake line or flexible hose, ensure that they are free from twists or bends.
*
If the metal end of a flexible hose does not match the groove on the bracket, twist the hose slightly to insert it.
*
Flexible hoses must be free from shock absorber oil, grease, etc.
*
When installing a brake line to a plastic clamp, ensure that the brake line is not loose or pinched.
*
Do not reuse any clips or plastic clamps removed from a flexible hose.
*
After installing a brake line or flexible hose, ensure that they do not interfere with any other components or body.
*
Do not allow brake fluid on any painted vehicle body surface. If brake fluid leaks onto any painted surface, immediately wash it
off.
*
When disconnecting and connecting a flexible hose and brake line:
*
Hold the flexible hose with a wrench and disconnect the brake tube using a union nut wrench without deforming the tube.
*
Remove the clip and disconnect the flexible hose.
*
Secure the flexible hose with a new clip. At this time, be sure to securely install the clip.
*
Connect the brake tube using a union nut wrench without deforming the tube.
*
When connecting a brake line and way: