Venza AWD V6-3.5L (2GR-FE) (2010)
Cruise Control Switch: Service and Repair
Installation
CRUISE CONTROL: CRUISE CONTROL MAIN SWITCH: INSTALLATION
1. INSTALL CRUISE CONTROL MAIN SWITCH
(a) Install the cruise control main switch with the 2 screws.
Torque : 2.4 Nm (24 kgf-cm, 21 in-lbf)
(b) Connect the connector.
2. INSTALL STEERING PAD See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering Pad/Installation
3. INSTALL LOWER NO. 3 STEERING WHEEL COVER See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering
Pad/Installation
4. INSTALL LOWER NO. 2 STEERING WHEEL COVER See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering
Pad/Installation
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
6. INSPECT STEERING PAD See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering Pad/Installation
7. INSPECT SRS WARNING LIGHT
See: Restraint Systems/Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System