Venza AWD V6-3.5L (2GR-FE) (2010)
Variable Valve Timing Actuator: Service and Repair
Installation
2GR-FE ENGINE CONTROL: CAMSHAFT OIL CONTROL VALVE: INSTALLATION
1. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY
(a) Apply a light coat of engine oil to 4 new O-rings and install them to the 4 camshaft timing oil control valve assemblies.
Text in Illustration
(b) Install the 4 oil control valves with the 4 bolts.
Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)
NOTICE:
Make sure that each O-ring is not cracked or does not jump out of position during installation.
(c) Connect the 4 oil control valve connectors.
(d) Install the bolt and connect the wire harness clamp to install the engine wire.
Torque : 14 Nm (138 kgf-cm, 10 ft-lbf)