Venza AWD V6-3.5L (2GR-FE) (2010)
INSPECTION PROCEDURE
PROCEDURE
1. CHECK THAT MIL ILLUMINATES
(a) Turn the ignition switch to ON.
(b) Check the illumination of the MIL.
Result:
C -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE See: Powertrain
Management/Computers and Control Systems/Testing and Inspection/Symptom Related Diagnostic Procedures
B -- CHECK IF ENGINE STARTS
A -- Continue to next step.
2. CHECK WHETHER MIL TURNS OFF
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Powertrain / Engine / Trouble Codes.