Venza AWD V6-3.5L (2GR-FE) (2010)
Fuel Injector: Service and Repair
Removal
2GR-FE FUEL: FUEL INJECTOR: REMOVAL
1. DISCHARGE FUEL SYSTEM PRESSURE
HINT
See: Service Precautions/Fuel System.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
3. REMOVE INTAKE AIR SURGE TANK ASSEMBLY
(a) Remove the intake air surge tank assembly See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and Repair/Removal.
4. DISCONNECT FUEL TUBE SUB-ASSEMBLY
(a) Remove the No. 2 fuel pipe clamp.
(b) Pinch the tube connector and pull out the fuel pipe.
NOTICE:
*
Check that there is no dirt or other foreign objects around the connector when disconnecting it. Clean the connector as necessary.
*
It is necessary to prevent dirt or foreign objects from entering the quick connector. If dirt or foreign objects get in the connector,
the O-rings may not seal properly.
*
Only disconnect the quick connector by hand.
*
Do not bend, kink or twist the nylon tubes.
*
Protect the connector by covering it with a plastic bag.
*
If the pipe and the connector are stuck, carefully try wiggling or pushing and pulling on the connector to release it. Pull the
connector off the pipe carefully.
5. REMOVE FUEL INJECTOR ASSEMBLY
(a) Disconnect the 6 fuel injector connectors.