Venza AWD V6-3.5L (2GR-FE) (2010)
Throttle Body: Service and Repair
Installation
2GR-FE ENGINE CONTROL: THROTTLE BODY: INSTALLATION
1. INSTALL THROTTLE BODY
(a) Install a new gasket to the intake air surge tank assembly.
(b) Install the throttle body and wire harness clamp stay to the intake air surge tank assembly with the 4 bolts.
Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)
(c) Connect the throttle body connector and wire harness clamp.
(d) Connect the 2 water by-pass hoses to the throttle body.
2. INSTALL AIR CLEANER CAP WITH HOSE
(a) Connect the air cleaner hose to the throttle body with the hose clamp.
(b) Install the air cleaner cap with hose to the air cleaner case with the 3 clamps.