Venza AWD V6-3.5L (2GR-FE) (2010)
Traction Control Switch: Service and Repair
Installation
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: VSC OFF SWITCH: INSTALLATION
1. INSTALL VSC OFF SWITCH
(a) Engage the 2 claws and install the VSC OFF switch.
2. INSTALL LOWER NO. 1 INSTRUMENT FINISH PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal and Replacement/Installation
3. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
and Replacement/Installation
4. INSTALL FRONT DOOR SCUFF PLATE LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
6. CHECK FOR WARNING LIGHT AND INDICATOR LIGHT
HINT
See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Initial Inspection and
Diagnostic Overview/Test Mode Procedure.