Venza AWD V6-3.5L (2GR-FE) (2010)
Torque : 29 Nm (296 kgf-cm, 21 ft-lbf)
6. INSTALL FRONT NO. 1 STABILIZER BRACKET RH
HINT
Perform the same procedure as the LH side.
7. INSTALL FRONT STABILIZER LINK ASSEMBLY LH
(a) Install the front stabilizer link assembly LH with the nut.
Torque : 74 Nm (755 kgf-cm, 55 ft-lbf)
HINT
If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud bolt.
8. INSTALL FRONT STABILIZER LINK ASSEMBLY RH
HINT
Perform the same procedure as the LH side.
9. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE
HINT
Refer to the procedure from Install Engine Assembly with Transaxle See: Engine, Cooling and Exhaust/Engine/Service and
Repair/Removal and Replacement/Engine Assembly/Installation.