Venza AWD V6-3.5L (2GR-FE) (2010)
(a) Inspect and adjust transfer oil See: Transfer Case/Fluid - Transfer Case/Testing and Inspection.
31. INSTALL CENTER EXHAUST PIPE ASSEMBLY
(a) Install the center exhaust pipe assembly.
HINT
Refer to the instructions for Installation of the exhaust pipe See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Pipe/Service
and Repair/Installation for 2GR-FE, See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Pipe/Service and
Repair/Installation for 1AR-FE).
32. ADD DIFFERENTIAL OIL
(a) for reused rear differential carrier assembly:
(1) Using a hexagon wrench (10 mm), install the rear differential drain plug with a new gasket.
Torque : 39 Nm (398 kgf-cm, 29 ft-lbf)
(2) Add differential oil See: Fluid - Differential/Service and Repair.
(b) for new rear differential carrier assembly:
(1) Using a hexagon wrench (10 mm), remove the rear differential carrier cover plug and gasket.
(2) Add differential oil See: Fluid - Differential/Service and Repair.
33. INSPECT AND ADJUST DIFFERENTIAL OIL See: Fluid - Differential/Service and Repair
34. INSTALL REAR DIFFERENTIAL CARRIER COVER PLUG See: Fluid - Differential/Service and Repair
35. INSPECT FOR EXHAUST GAS LEAK
36. INSTALL REAR WHEELS
Torque : 105 Nm (1050 kgf-cm, 76 ft-lbf)
37. STABILIZE SUSPENSION See: Steering and Suspension/Suspension/Control Arm/Service and Repair/Rear Lower Arm/Installation
38. FULLY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY LH See: Steering and Suspension/Suspension/Control Arm/Service and
Repair/Rear Lower Arm/Installation
39. FULLY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY RH See: Steering and Suspension/Suspension/Control Arm/Service and
Repair/Rear Lower Arm/Installation
40. INSPECT AND ADJUST REAR WHEEL ALIGNMENT