Venza AWD V6-3.5L (2GR-FE) (2010)
(c) Using a hexagon wrench (10 mm), install the rear differential drain plug with a new gasket.
Torque : 39 Nm (398 kgf-cm, 29 ft-lbf)
(d) Using a hexagon wrench (10 mm), temporarily install the rear differential carrier cover plug.
HINT
Add differential oil before installing a new gasket and fully tightening the rear differential carrier cover plug.
4. REMOVE ELECTRO MAGNETIC CONTROL COUPLING SUB-ASSEMBLY
(a) Disconnect the electro magnetic control coupling sub-assembly connector and vacuum hose.
NOTICE:
Do not damage the electro magnetic control coupling wire harness.
(b) Remove the 4 bolts.
(c) Using a brass bar and a hammer, tap the electro magnetic control coupling sub-assembly to remove the electro magnetic control coupling
sub-assembly from the rear differential carrier assembly.
NOTICE:
Do not drop the electro magnetic control coupling sub-assembly.
5. REMOVE TRANSMISSION COUPLING CONICAL SPRING WASHER
(a) Remove the transmission coupling conical spring washer from the rear differential carrier assembly.