Venza AWD V6-3.5L (2GR-FE) (2010)
SST : 09517-30010
SST : 09631-32020
Oil seal driven in depth (A):
4.2 to 4.8 mm (0.165 to 0.189 in.)
(b) Apply a light coat of MP grease to the lip of the new rear differential side gear shaft oil seal.
15. INSTALL REAR DRIVE SHAFT SNAP RING See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Overhaul/Rear
Drive Shaft Assembly/Reassembly
16. INSTALL REAR DRIVE SHAFT ASSEMBLY
(a) Align the matchmarks and insert the rear drive shaft assembly to the rear axle assembly.
Text in Illustration
(b) Insert the rear drive shaft assembly to the rear differential carrier assembly while pushing the rear axle assembly towards the outside of the
vehicle.
Text in Illustration
NOTICE:
Do not disjoint inboard of the drive shaft.