Venza AWD V6-3.5L (2GR-FE) (2010)
28. INSPECT FOR DIFFERENTIAL OIL LEAK
29. INSTALL REAR WHEEL
Torque : 105 Nm (1050 kgf-cm, 76 ft-lbf)
30. STABILIZE SUSPENSION See: Steering and Suspension/Suspension/Control Arm/Service and Repair/Rear Lower Arm/Installation
31. FULLY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY See: Steering and Suspension/Suspension/Control Arm/Service and
Repair/Rear Lower Arm/Installation
32. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
(a) Inspect and adjust the rear wheel alignment See: Maintenance/Alignment/Service and Repair.
33. CHECK FOR SPEED SENSOR SIGNAL
(a) Check for the speed sensor signal See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and
Inspection/Initial Inspection and Diagnostic Overview/Test Mode Procedure.
34. HEIGHT CONTROL SENSOR SIGNAL INITIALIZATION (w/ HID Headlight System)
(a) Initialize the height control sensor signal See: Lighting and Horns/Testing and Inspection/Programming and Relearning/Exterior Lighting
System/Initialization.
35. INSPECT AND ADJUST HEADLIGHT AIMING (w/ HID Headlight System)
(a) Inspect and adjust the headlight aiming See: Lighting and Horns/Headlamp/Adjustments.