Venza FWD L4-2.7L (1AR-FE) (2009)
headlining assembly.
HINT:
-
If the tape has lost adhesion, use other tape, such as packing tape, with enough adhesion to secure the antenna cord and washer hose to the
roof headlining assembly.
-
Secure the antenna cord and washer hose to the roof headlining assembly with tape as shown in the illustration.
10. INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY (w/ Sliding Roof)
(a) Aligning the No. 2 antenna cord sub-assembly and rear No. 2 washer hose with the markings on the roof headlining assembly, temporarily
install the cord and washer hose.
(b) Put the strips of the tape back to the positions shown in the illustration in order to secure the antenna cord and washer hose to the roof
headlining assembly.
HINT:
-
If the tape has lost adhesion, use other tape, such as packing tape, with enough adhesion to secure the antenna cord and washer hose to the
roof headlining assembly.
-
Secure the antenna cord and washer hose to the roof headlining assembly with tape as shown in the illustration.
11. INSTALL ROOF HEADLINING ASSEMBLY
HINT: Refer to the procedure from Install Roof Headlining Assembly See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Installation.
12. INSTALL NO. 1 ANTENNA CORD SUB-ASSEMBLY
(a) Engage the 7 clamps to install the No. 1 antenna cord sub-assembly.
13. INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY
HINT: Refer to the procedure from Install Instrument Panel Safety Pad Assembly See: Body and Frame/Interior Moulding / Trim/Dashboard
/ Instrument Panel/Service and Repair/Installation.