Venza FWD L4-2.7L (1AR-FE) (2009)
Hood Latch Release Cable: Service and Repair
Installation
DOOR / HATCH: HOOD LOCK CONTROL CABLE ASSEMBLY: INSTALLATION
INSTALLATION
1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY
(a) Pass the hood lock control cable assembly into the engine compartment.
Text in Illustration
(b) Pass the cable through the upper radiator support.
(c) Engage the clamps shown in the illustration.
2. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL See: Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Installation
3. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH See: Interior Moulding / Trim/Headliner/Service and Repair/Installation
4. INSTALL FRONT DOOR SCUFF PLATE LH See: Interior Moulding / Trim/Headliner/Service and Repair/Installation
5. INSTALL HOOD LOCK ASSEMBLY (w/o Engine Hood Courtesy Switch)
(a) Apply MP grease to the sliding areas of the lock.