Venza FWD L4-2.7L (1AR-FE) (2009)
Power Trunk / Liftgate Hazard Sensor: Service and Repair
Installation
DOOR / HATCH: POWER BACK DOOR TOUCH SENSOR: INSTALLATION
INSTALLATION
1. INSTALL POWER BACK DOOR TOUCH SENSOR ASSEMBLY
(a) Tie the string to the wire near the connector of the power back door touch sensor assembly.
HINT: Use the string that was left in the door during removal of the touch sensor assembly.
(b) Pull the string to help pass the connector through the inside of the back door frame.
(c) Engage the 2 clips.
(d) Install the power back door touch sensor assembly with the 5 bolts.
(e) Connect the connector.
2. INSTALL BACK DOOR TRIM COVER See: Service and Repair/Reassembly
3. CONNECT POWER BACK DOOR ROD (for LH Side) See: Service and Repair/Reassembly
4. INSTALL BACK DOOR PANEL TRIM ASSEMBLY See: Service and Repair/Reassembly
5. INSTALL UPPER BACK WINDOW PANEL TRIM See: Service and Repair/Reassembly