Venza FWD L4-2.7L (1AR-FE) (2009)
(a) Disengage the 2 claws, guide and 2 clips, and remove the lower center pillar garnish LH as shown in the illustration.
10. REMOVE UPPER CENTER PILLAR GARNISH LH
(a) Remove the screw.
(b) Using a clip remover, disengage the clip.
(c) Pass the floor anchor of the front seat outer belt assembly LH through the upper center pillar garnish LH and remove the upper center pillar
garnish LH.
11. REMOVE FRONT DOOR SCUFF PLATE RH
HINT: Use the same procedure for the RH side and the LH side.
12. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH
HINT: Use the same procedure for the RH side and the LH side.
13. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH
HINT: Use the same procedure for the RH side and the LH side.
14. REMOVE FRONT PILLAR GARNISH RH
HINT: Use the same procedure for the RH side and the LH side.
15. REMOVE REAR DOOR SCUFF PLATE RH
HINT: Use the same procedure for the RH side and the LH side.
16. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH
HINT: Use the same procedure for the RH side and the LH side.
17. REMOVE LAP BELT OUTER ANCHOR COVER (for RH Side)
HINT: Use the same procedure for the RH side and the LH side.
18. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY RH
HINT: Use the same procedure for the RH side and the LH side.
19. REMOVE LOWER CENTER PILLAR GARNISH RH
HINT: Use the same procedure for the RH side and the LH side.
20. REMOVE UPPER CENTER PILLAR GARNISH RH
HINT: Use the same procedure for the RH side and the LH side.