Venza FWD L4-2.7L (1AR-FE) (2009)
(a) Using a clip remover, disengage the 4 claws.
Text in Illustration
NOTICE: Do not forcibly pry the assist grip covers to prevent them from being deformed.
-
Gently pry on the assist grip covers as shown in the illustration to remove them.
-
Tape the clip remover tip before use.
(b) Pull off the 2 assist grip covers by hand.
(c) Disengage the 2 clips and remove the rear assist grip assembly.
(d) Remove the 2 clips from the vehicle body.
HINT: Use the same procedure for the RH side and the LH side.
62. REMOVE ASSIST GRIP SUB-ASSEMBLY (w/ Sliding Roof)
(a) Using a screwdriver, disengage the 6 claws and remove the 2 assist grip covers.
Text in Illustration