Venza FWD L4-2.7L (1AR-FE) (2009)
Power Trunk / Liftgate Hazard Sensor: Service and Repair
Removal
DOOR / HATCH: POWER BACK DOOR TOUCH SENSOR: REMOVAL
REMOVAL
1. REMOVE UPPER BACK WINDOW PANEL TRIM See: Doors, Hood and Trunk/Trunk / Liftgate/Service and Repair/Disassembly
2. REMOVE BACK DOOR PANEL TRIM ASSEMBLY See: Doors, Hood and Trunk/Trunk / Liftgate/Service and Repair/Disassembly
3. DISCONNECT POWER BACK DOOR ROD (for LH Side) See: Doors, Hood and Trunk/Trunk / Liftgate/Service and Repair/Disassembly
4. REMOVE BACK DOOR TRIM COVER See: Doors, Hood and Trunk/Trunk / Liftgate/Service and Repair/Reassembly
5. REMOVE POWER BACK DOOR TOUCH SENSOR ASSEMBLY
(a) Disconnect the connector.
(b) Remove the 5 bolts.
(c) Disengage the 2 clips.
(d) Tie a string to the wire near the connector of the power back door touch sensor assembly.
(e) Remove the power back door touch sensor assembly.
HINT: Leave the string inside the back door frame because it will be used for installation.
(f) Untie the string from the power back door touch sensor assembly.