Venza FWD L4-2.7L (1AR-FE) (2009)
Steering Angle Sensor: Service and Repair
Installation
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: STEERING ANGLE SENSOR: INSTALLATION
INSTALLATION
1. INSTALL SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY
(a) Install the spiral with sensor cable sub-assembly See: Restraint Systems/Air Bag Systems/Clockspring Assembly / Spiral Cable/Service and
Repair/Installation.
NOTICE:
-
Do not replace the spiral cable with the battery connected and the engine switch on (IG).
-
Do not rotate the spiral cable with the battery connected and the engine switch on (IG).
-
Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.
-
Do not remove the steering sensor from the spiral cable.
-
Never use the steering angle sensor detached from spiral cable.
HINT: The steering angle sensor is a component of the spiral with sensor cable sub-assembly. If the steering angle sensor malfunctions,
replace the spiral with sensor cable sub-assembly.
2. INSTALL UPPER STEERING COLUMN COVER See: Steering and Suspension/Steering/Steering Column/Service and Repair/Removal and
Replacement/Installation
3. INSTALL LOWER STEERING COLUMN COVER See: Steering and Suspension/Steering/Steering Column/Service and Repair/Removal and
Replacement/Installation
4. ADJUST SPIRAL CABLE See: Restraint Systems/Air Bag Systems/Clockspring Assembly / Spiral Cable/Service and Repair/Installation
5. INSTALL STEERING WHEEL ASSEMBLY See: Steering and Suspension/Steering/Steering Wheel/Service and Repair/Installation
6. INSPECT STEERING WHEEL CENTER POINT
7. INSTALL STEERING PAD See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering Pad/Installation
8. INSTALL LOWER NO. 3 STEERING WHEEL COVER See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering
Pad/Installation
9. INSTALL LOWER NO. 2 STEERING WHEEL COVER See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering
Pad/Installation
10. INSPECT STEERING PAD See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering Pad/Installation
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Repair Instruction - Initialization.
12. INSPECT SRS WARNING LIGHT See: Restraint Systems/Air Bag Systems/Clockspring Assembly / Spiral Cable/Service and Repair/Installation