Venza FWD L4-2.7L (1AR-FE) (2009)
Drive Belt: Service and Repair
Installation
1AR-FE ENGINE MECHANICAL: DRIVE BELT: INSTALLATION
INSTALLATION
1. INSTALL V-RIBBED BELT
(a) Set the V-ribbed belt onto each part as shown in the illustration except the water pump pulley.
Text in Illustration
(b) Loosen the V-ribbed belt by turning the belt tensioner clockwise.
(c) Set the V-ribbed belt onto the water pump pulley.
NOTICE: Make sure that the belt is attached to each pulley. In particular, make sure that the belt is securely fitted into the grooves of the
crankshaft pulley.
2. INSTALL FRONT FENDER APRON SEAL RH See: Service and Repair/Removal and Replacement/Engine Assembly/Installation
3. INSTALL FRONT FENDER LINER RH
4. INSTALL NO. 1 ENGINE UNDER COVER
5. INSTALL FRONT WHEEL RH
Torque: 103 Nm (1050 kgf-cm, 76ft-lbf)