Venza FWD L4-2.7L (1AR-FE) (2009)
Condenser HVAC: Service and Repair
Installation
HEATING / AIR CONDITIONING: CONDENSER: INSTALLATION
INSTALLATION
1. INSTALL COOLER CONDENSER ASSEMBLY
(a) Install the cooler condenser assembly with the 4 bolts.
Torque: 6.0 Nm (61 kgf-cm, 53in-lbf)
HINT: If the condenser is replaced with a new one, add compressor oil to the new condenser.
Capacity:
40 cc (1.35 fl.oz.)
Compressor oil:
ND-OIL 8 or equivalent
2. CONNECT AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY
(a) Remove the attached vinyl tape from the tube and the connecting part of the cooler condenser assembly.
(b) Sufficiently apply compressor oil to a new O-ring and the fitting surface of the tube joint.
Compressor oil:
ND-OIL 8 or equivalent
(c) Install the O-ring on the air conditioning tube and accessory.
NOTICE: Keep the O-ring and O-ring fitting surfaces clean from dirt or any foreign objects.
(d) Install the air conditioning tube and accessory on the cooler condenser assembly with the bolt.
Torque: 9.8 Nm (100 kgf-cm, 87in-lbf)
3. CONNECT COOLER REFRIGERANT DISCHARGE HOSE
(a) Remove the attached vinyl tape from the pipe and the connecting part of the cooler condenser assembly.
(b) Sufficiently apply compressor oil to a new O-ring and the fitting surface of the pipe joint.
Compressor oil:
ND-OIL 8 or equivalent
(c) Install the O-ring on the discharge hose.
NOTICE: Keep the O-ring and O-ring fitting surfaces clean from dirt or any foreign objects.