Venza FWD L4-2.7L (1AR-FE) (2009)
Tire Pressure Module: Service and Repair
Removal
TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING ECU: REMOVAL
REMOVAL
NOTICE: Before removing the tire pressure warning ECU, read the registered transmitter IDs of all wheels and write them down to use for
re-registration of transmitter IDs See: Testing and Inspection/Programming and Relearning.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Repair Instruction - Initialization.
2. REMOVE FRONT DOOR SCUFF PLATE RH See: Dashboard / Instrument Panel/Service and Repair/Removal
3. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH See: Dashboard / Instrument Panel/Service and Repair/Removal
4. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY See: Dashboard / Instrument Panel/Service and Repair/Removal
5. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY See: Dashboard / Instrument Panel/Service and Repair/Removal
6. REMOVE TIRE PRESSURE WARNING ECU
(a) Remove the nut.
(b) Disconnect the connector to remove the tire pressure warning ECU.