Venza FWD L4-2.7L (1AR-FE) (2009)
1. CHECK CAN BUS WIRE FOR DISCONNECTION (CENTER AIRBAG SENSOR ASSEMBLY BRANCH WIRE)
(a) Turn the ignition switch off.
(b) Disconnect the connector of the center airbag sensor assembly.
Text in Illustration
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- REPAIR OR REPLACE CAN BUS BRANCH WIRE OR CONNECTOR (CENTER AIRBAG SENSOR ASSEMBLY
BRANCH WIRE)
OK -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (POWER SOURCE TERMINAL)
(a) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Text in Illustration