Venza FWD L4-2.7L (1AR-FE) (2009)
(b) Install the oil control valve with the bolt.
Torque: 10 Nm (102 kgf-cm, 7ft-lbf)
NOTICE:
-
Do not allow foreign matter to contact the oil seal face of the oil control valve (connecting surface with cylinder head cover).
-
Be careful that the O-ring is not cracked or moved out of place when installing the oil control valve.
(c) Connect the oil control valve connector.
3. INSPECT FOR OIL LEAK
4. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Engine Assembly/Installation