Venza FWD L4-2.7L (1AR-FE) (2009)
(c) Rotate the spiral cable counterclockwise slowly by hand until it stops.
NOTICE: Do not turn the spiral cable using the airbag wire harness.
(d) Rotate the spiral cable clockwise approximately 2.5 turns to align the alignment marks.
Text in Illustration
NOTICE: Do not turn the spiral cable using the airbag wire harness.
HINT: The spiral cable will rotate approximately 2.5 turns to both the left and right from the center.
6. INSTALL STEERING WHEEL ASSEMBLY See: Steering and Suspension/Steering/Steering Wheel/Service and Repair/Installation
7. INSTALL STEERING PAD See: Air Bag/Service and Repair/Steering Pad/Installation
8. INSTALL LOWER NO. 3 STEERING WHEEL COVER See: Air Bag/Service and Repair/Steering Pad/Installation
9. INSTALL LOWER NO. 2 STEERING WHEEL COVER See: Air Bag/Service and Repair/Steering Pad/Installation
10. INSPECT STEERING WHEEL CENTER POINT
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Repair Instruction - Initialization.
12. INSPECT STEERING PAD See: Air Bag/Service and Repair/Steering Pad/Installation
13. PERFORM DIAGNOSTIC SYSTEM CHECK
(a) Perform a diagnostic system check See: Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/DTC Check / Clear.
14. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System.